Intellinet-network ICC-130 Hardware Installation Guide Uživatelský manuál stáhnout pdf (Strana 4)

Factory Reset

Reset: With the camera turned on, press the reset button briefly to

reboot the camera, or hold the reset button for 10 seconds to set all

settings back to factory default values.

Hardware Installation

1. Use the two supplied screws to fix the base plate to a flat surface.

2. Loosen the screws on the bracket in order to adjust the camera’s

viewing area.

3. Tighten the screws at the two joints of the bracket to fix the camera

in place.

4. Above: It is recommended to install the network camera in an area where the

camera is not directly exposed to sun light, rain or snow. For example, install the

camera underneath an overhang, such as a roof, to increase the camera’s life

span.

1 2 3 4 5 6

Žádné komentáře

Intellinet-network ICC-130 Hardware Installation Guide Uživatelský manuál Strana 4